Rodeo Sport 2WD V6-3.2L (2001)
17.
Caution:
To prevent injury to the technician and damage to the vehicle, place a pad over the engine and the radiator grille.
18.
Using a 90-degree needle nose pliers, remove both fuel hose clamps behind common chamber (Figure 13).
NOTE:
Spraying some silicone fluid on the hose clamps will ease hose clamp removal.
19.
Carefully use a blade to cut both high and low pressure hoses to allow for easy removal from the fuel lines (Figure 14).
20.
Pull both high and low pressure hoses away from the fuel lines, and discard old Fuel Hose Kit.
21.
Install new Fuel Hose Clips on the Fuel Rose Kit and install the new Fuel Hose Kit onto the fuel lines. Then slide Fuel Hose Clips in place to
secure the Fuel Hose Kit onto the lines.
22.
Lower the floor jack and raise the vehicle on the hoist.
