Rodeo Sport 2WD V6-3.2L (2001)
Intake Air Duct: Service and Repair
Removal
1. Disconnect battery ground cable.
2. Remove air cleaner duct assembly.
3. Disconnect vacuum booster hose from common chamber.
4. Disconnect connector from manifold absolute pressure sensor, Ion sensing module, throttle position sensor, solenoid valve, electric vacuum
sensing valve, and EGR valve.
5. Disconnect vacuum hose on canister VSV and positive crankcase ventilation hose, fuel rail assembly with pressure control valve bracket.
6. Remove ventilation hose from throttle valve and intake duct and remove water hose.
7. Remove the four throttle body fixing bolts.
8. Remove exhaust gas recirculation valve assembly fixing bolt and nut on common chamber and remove EGR valve assembly.
9. Remove two bolts from common chamber rear side to remove fuel hose bracket.
10. Remove common chamber four bolts and four nuts then remove the common chamber
Installation
1. Install common chamber and tighten bolts and nuts to the specified torque.
Torque:
Bolt: 25 Nm (18 ft. lbs.)
Nut: 25 Nm (18 ft. lbs.)
2. Install fuel hose bracket and tighten bolts to specified torque.
Torque: 10 Nm (87 inch lbs.)
3. Install exhaust gas recirculation valve assembly and tighten bolt and nut to the specified torque.
