Rodeo Sport 2WD V6-3.2L (2001)
Fuel Pressure Sensor: Testing and Inspection
Typical Scan Data Values
Use the Typical Scan Data Values Table only after the On-Board Diagnostic System Check has been completed, no DTC(s) were noted, and you have
determined that the on-board diagnostics are functioning properly. Tech 2 values from a properly-running engine may be used for comparison with the
engine you are diagnosing. The typical scan data values represent values that would be seen on a normally-running engine.
NOTE: A Tech 2 that displays faulty data should not be used, and the problem should be reported to the Tech 2 manufacturer. Use of a faulty Tech 2
can result in misdiagnosis and unnecessary replacement of parts.
Only the parameters listed below are referred to in this service manual for use in diagnosis. For further information on using the Tech 2 to diagnose the
PCM and related sensors, refer to the applicable reference section listed below. If all values are within the typical range described below, refer to the
Diagnosis By Symptom.
