Rodeo Sport 2WD V6-3.2L (2001)
NOTE: SRS coil is a part of combination switch assembly, which cannot be rep laced separately. Therefore, be sure not to remove the SRS coil
from the combination switch assembly.
14. Remove the snap ring.
15. Remove the cushion rubber.
16. Disconnect shift lock cable (A/T only)
17. Disconnect the starter switch harness connector (12) located base of steering column.
18. Remove steering lock cylinder assembly (11).
19. Apply a setting mark across the universal joint and steering shaft to reassemble the parts in their original position.
20. Remove steering column assembly (13).
Installation
1. Install the steering column assembly (13) and align the setting marks on the universal joint and steering shaft made during removal.
2. Tighten the steering column fixing bolts (dash panel side) to the specified torque.
Torque: 20 N.m (14 lb ft)
3. Tighten the steering column fixing nuts (Gross beam) to the specified torque.
Torque: 20 N.m (14 lb ft)
4. Tighten the universal joint to the specified torque.
Torque: 31 N.m (23 lb ft)
5. Install steering lock cylinder assembly (11).
6. Connect shift lock cable (For A/T)
7. Install cushion rubber.
8. Install snap ring.
9. Install the combination switch assembly with SRS coil (9).
10. Connect the wiring harness connector (10) located on the base of steering column.
11. Turn the SRS coil clockwise to full, return about 3 turns and align the neutral mark.
CAUTION: When turning the SRS coil clockwise to full, stop turning if resistance is felt. Further forced turning may damage the cable in the
SRS coil.
12. Install steering column cover (1).
CAUTION: When installing the steering column cover, be sure to wire (through each harness) as illustrated so that the harnesses starter switch,
combination switch and SRS coil may not catch wiring.
13. Install the steering wheel (2) and align the setting marks (6).
14. Tighten the steering wheel fixing nut (3) to the specified torque.
Torque: 34 N.m (25 lb ft)
15. Connect horn lead (8).
16. Connect air Bag wiring harness connector (7).
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air bag to prevent lead wire from being pinched.
