Rodeo Sport 2WD V6-3.2L (2001)
8. Remove the luggage side trim cover (RH).
-
Remove the jack & tool lid and remove the tool.
-
Remove fixing screw and pry the trim cover retainers free from the body panel.
9. Remove the luggage side trim cover (LH).
-
Remove fixing screw and pry the trim cover retainers free from the body panel.
-
Disconnect the accessory socket connectors.
10. Remove the cap and seat belt lower anchor bolt.
11. Remove the shoulder anchor cover (2).
Release the hooked portion of cover from the shoulder anchor (1).
12. Remove the seat belt upper anchor bolt.
13. Remove the retractor.
14. Remove the rear seat belt assembly.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Align the projection of the retractor to the square hole of the seat belt cross bar assembly bracket.
2. Tighten the retractor fixing bolts to the specified torque.
Torque: 39 N.m (29 lb ft)
3. Tighten the seat belt anchor bolt to the specified torque.
Torque: 39 N.m (29 lb ft)
