Rodeo Sport 4WD V6-3.2L (2002)
-
Disconnect the power window switch connector.
7. Remove the bracket.
8. Peel the upper half of the waterproof sheet.
-
Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.
9. Disconnect the locking links and remove the door lock assembly fixing screws to remove the door lock assembly.
Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Apply chassis grease to the lock assembly and striker moving surface.
2. Install the regulator handle as shown in the illustration, if equipped without power windows.
3. Tighten the door lock assembly fixing screws to the specified torque.
Torque: 7 N.m (61 lb in)
