Rodeo Sport 4WD V6-3.2L (2002)
4. Remove the seat cushion hinges.
5. Remove the rear cushion trim cover (1) and rear seat cushion pad (2).
-
Remove cushion trim cover from the rear cushion frame (3) by prying on the plastic retainers (4).
6. Remove the rear seat lock assembly and rear seat belt buckle assembly.
7. Remove the rear seat lock strikers.
-
Remove the four bolts at each striker.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Tighten the rear seat lock assembly and rear seat belt buckle assembly fixing bolts to the specified torque.
Torque: 39 N.m (29 lb ft)
2. Tighten the rear seat lock striker fixing bolts to the specified torque.
Torque: 39 N.m (29 lb ft)
3. Tighten the seat cushion hinge fixing bolts to the specified torque.
Torque: 39 N.m (29 lb ft)