Rodeo Sport 4WD V6-3.2L (2002)
Ignition Coil: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Ignition coil connector and ignition coil.
-
Disconnect three connector from ignition coil.
-
Remove harness bracket bolt on cylinder head cover.
-
Remove fixing bolts on ignition coil.
INSTALLATION
1. Install the ignition coil assembly (3).
Connect ignition coil connector (1) and ignition coil (3), then tighten bolt (2) to the specified torque.
Torque: 4 N.m (35.4 lb in)
CAUTION: Ignition coil assembly #6 is different from ignition coil assembly from #1 to #5. Ignition coil assembly #6 is short type. So, note it
when installing ignition coil assembly of #6.