Rodeo Sport 4WD V6-3.2L (2002)
3. Install the combination switch assembly (with SRS coil) to steering lock of steering shaft and tighten the four bolts to a specified tightening torque.
4. Connect the wiring harness connectors (10) located at the base of steering column.
5. Turn the SRS coil clockwise to full, return about 3 turns and align the neutral mark.
Note: Whenever installing the new combination switch with SRS coil, be sure to tear off the lock pin for aligning the neutral position before it is
installed to the base of steering column.
6. Install the steering column cover (3).
CAUTION: When installing the steering column cover, be sure that all harnesses (i.e., starter switch, combination switch, and SRS coil) are not
pinched and installed according to the diagram.
7. Install the driver knee bolster assembly.
