Rodeo Sport 4WD V6-3.2L (2002)
Installation
1. Install the 2nd shaft (14) to the column shaft assembly (13).
2. Install the steering column assembly (13).
3. Tighten the steering column fixing bolts (dash panel side) to the specified torque.
Torque: 20 N.m (2.0 kg m / 15 lb ft)
4. Tighten the steering column fixing nuts (Cross beam) to the specified torque.
Torque: 17 N.m (1.7 kg m / 13 lb ft)
5. Tighten the universal joint to the specified torque.
Torque: 31 N.m (3.2 kg m / 23 lb ft)
6. Install steering lock cylinder assembly (11).
7. Connect shift lock cable.
8. Install cushion rubber.
9. Install snap ring.
10. Install the combination switch assembly with Supplemental Restraint System (SRS) coil (9).
11. Connect the wiring harness connector (10) located on the base of steering column.
12. Turn the SRS coil clockwise to full, return about 3 turns and align the neutral mark.
CAUTION: Turn the SRS coil clockwise until a resistance is felt, do not over turn or SRS coil breakage may occur.
