Rodeo Sport 4WD V6-3.2L (2002)
11. Remove lower ball joint by using remover J-29107.
Caution: Be careful not to damage the ball joint boot
12. Remove upper ball joint by using remover J-36831.
Caution: Be careful not to damage the ball joint boot
13. Remove knuckle assembly.
14. Remove oil seal (Except 2WD model).
Inspection and Repair
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection.
Check the following parts:
^
Knuckle
^
Knuckle arm
Installation
1. Use a new oil seal, and apply multipurpose type grease to the area surrounded by the lip (approximately 2 g). Then use installer J-45647 and
J-8092 to install oil seal. After fitting the oil seal to the installer, drive it to the knuckle using a hammer or bench press (Except 2WD model).
2. Install knuckle assembly.
