Rodeo Sport 4WD V6-3.2L (2002)
Slip Joint Reassembly
1. Apply grease evenly to both the female and male splines.
2. Apply a small amount of grease by finger to the outer lips of the boot.
3. Slide the boot (smaller diameter side) onto the spline yoke shaft being careful not to damage the spline coating or boot.
4. Carefully insert the spline yoke shaft into the tube assembly being careful to maintain proper phasing. The spider holes should be in line according
to the marks made prior to disassembly.
5. Position boot over tube assembly and yoke shaft in its assembled position over boot grooves.
6. Attach boot clamps and secure using pliers.
7. Be sure clamp is properly seated and secure.
Caution: Use a new clamp similar to original clamp. Use of any other clamp may cause shaft imbalance and/or grease leakage.
