Rodeo Sport 4WD V6-3.2L (2002)
Static runout limit:
^
0.13 mm (0.005 inch)
TIR on the neck of the slip tube shaft (with a boot).
^
0.25 mm (0.010 inch)
TIR on the ends of the tubing 3 inch from the welds.
^
0.38 mm (0.015 inch)
TIR at the linear center of the tube.
^
0.38 mm (0.015 inch)
TIR for the full length of tube with 30" or less of tubing. (TIR: Total Indicator Reading)
Spline
The nylon-coated spline should be free from nicks and dings and the underlying steel spline should not be visible.
After cleaning the nylon coating spline, the coating should exhibit only a slight indication of wear.
Grease volume is approximately 10 grams of grease in total. Grease should be evenly applied to both the female and the male slip splines using a small
brush. After assembly of the slip joint, the sliding joint should be fully worked from the full collapsed to the full extended position.
Play in the universal joint
Limit: Less than 0.15 mm (0.006 inch)
Preload of the universal joint
