Rodeo Sport 4WD V6-3.2L (2002)
cup assembly.
2. Move one end of the spider to cause a trunnion to project through the spider hole beyond the outer machined face of the yoke lug. Place a bearing
over the trunnion diameter and align it to the spider hole.
Using an arbor press, hold the trunnion in alignment with the spider hole and place a solid plug on the upper bearing. Press the bearing into the
spider hole enough to install snap ring.
3. Install a snap ring.
Note: Be sure the snap rings are properly seated in the grooves.
4. Repeat steps 2 and 3 to install the opposite bearing. If the joint is stiff, strike the yoke ears with a soft hammer to seat the bearing.
5. Align the setting marks and join the yokes.
