isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

ECM Diagnosis - Diagnosis Specifications Correction|Page 1132 > < ECM Diagnosis - Diagnosis Specifications Correction|Page 1130
Page 12
background image

Fig. 6E2-39

6E2-64 DRIVEABILITY AND EMISSIONS (DOHC)

CODE 44

OXYGEN SENSOR CIRCUIT (LEAN EXHAUST INDICATED)

Circuit Description:

The ECM supplies a voltage of about .43 volt between terminals "C46-23" and "C46-22". (If measured with a 10 megohm digital voltmeter, this may
read as low as .32 volts.) The O2 sensor varies the voltage within a range of about 1 volt, if the exhaust is rich, down through about .10 volt, if exhaust is
lean. The sensor is like an open circuit and produces no voltage, when it is below about 360~ (600~F). An open sensor circuit, or cold sensor, causes
"Open Loop" operation.

Test Description:

Numbers below refer to circled numbers on the diagnostic chart.

(1)

Code 44 is set, when the 0, sensor signal voltage is fixed below .280 mV) and the following:

^ TPS greater than 10% (A/T) 8% (M/T)
^ No code 21 or 33.
^ System is operating in "Closed Loop".
^ Temperature below 69.5~C (155~F).
^ Integrator not at 128.

Diagnostic Aids:

Using the "Scan" tool, observe the block learn value at different rpms. The "Scan" tool, also displays the block cells, so the block learn values can be
checked in each of the cells, to determine when the Code 44 may have been set. If the conditions for Code 44 exist, the block learn values will be around
150.

^ O2 Sensor Wire - Sensor pigtail may be mispositioned and contacting the exhaust manifold.
^ Check for ground in wire between connector and sensor.
^ Fuel Contamination - Water, even in small amounts, near the in-tank fuel pump inlet can be delivered to the injector. The water causes a lean

exhaust and can set a Code 44.

^ Fuel Pressure - System will be lean if pressure is too low. It may be necessary to monitor fuel pressure, while driving the car at various road

speeds and/or loads to confirm. See Fuel System diagnosis CHART A-5.

^ Exhaust Leaks - If there is an exhaust leak, the engine can cause outside air to be pulled into the exhaust and past the sensor. Vacuum or

crankcase leaks can cause a lean condition.

^ If Code 44 intermittent, refer to Section "B".

Page 6E2-66 DOHC Code 45 - O2 Rich Exhaust Indicated

Fig. 6E2-40

6E2-66 DRIVEABILITY AND EMISSIONS (DOHC)

ECM Diagnosis - Diagnosis Specifications Correction|Page 1132 > < ECM Diagnosis - Diagnosis Specifications Correction|Page 1130