Trooper (2 Door) V6-3165cc 3.2L DOHC (6VD1) (1992)
a. Place selector lever in neutral.
b. Disconnect mode switch connector from vehicle harness.
c. Connect multimeter (resistance mode) to terminals 1(E) and 4(H) on mode switch connector.
d. Loosen two mounting screws.
e. Rotate mode switch slightly in both directions to determine the range (approx. 5 degrees) of electrical contact.
f. Position mode switch in middle of contact range.
g. Tighten two mounting screws.
Torque: 13 Nm (113 in.lbf.)
h. Remove multimeter and reconnect harness.