Trooper (2 Door) V6-3165cc 3.2L DOHC (6VD1) (1992)
2.
Remove and discard rubber stoppers from each side of glovebox.
3.
Install a new, longer rubber stopper listed in "Parts Information" section of this Service Bulletin) to both sides of the glovebox.
4.
Reinstall glovebox.
^
Use the existing Flat Rate Manual labor operation.
Repair Chart I
Complaint: Rattle from rear seat
Cause: Rear seatback release knob loose
Repair:
1.
Remove rear seatback release knob.
2.
Prepare a 2-inch length of 1/2" diameter heat-shrinkable tubing (see "Parts Information" section of this Service Bulletin).
CAUTION
Use only a heat gun to shrink tubing. Do not use an open flame. Use a suitable tool to hold the knob when applying heat.
3.
Slide the tubing over the seatback release knob shaft. Trim excessive tubing length to within 1/8" beyond end of shaft. Apply heat to tubing until it
is completely shrunk over the shaft.
4.
Trim tubing to within 1/16" above end of shaft.
5.
Reinstall the rear seatback release knob securely.
6.
Repeat procedure on release knob on other side of rear seat.
^
Use the new Flat Rate Manual labor operation(s).
Repair Chart J
Complaint: Squeak in upper left side of instrument panel hood
Cause: Hood rubbing against instrument panel
Repair:
1.
Remove the instrument panel hood assembly as described in the appropriate Workshop Manual.