Trooper (2 Door) V6-3165cc 3.2L DOHC (6VD1) (1992)
^
Lift lip of windshield molding away from A-pillar. Insert nozzle of Three-Bond 1207B Silicone Gasket (Part No. 2-90067-801-0) under lifted lip and
apply bead of silicone gasket along full length of A-pillar (Figure 1).
IMPORTANT!
Be sure to seal the entire area under the windshield molding between the windshield and the A-pillar.
^
Remove nozzle from under windshield molding lip and press windshield molding against A-pillar using fingers to smooth out and ensure flush fit.
Allow silicone gasket to set for five (5) minutes.
CLEANING
A-Pillar (Right/Left)
^
Clean all excess silicone gasket from affected area using suitable adhesive cleaner.
PARTS INFORMATION
Part Number
Description
Quantity Required
2-90067-801-0
Gasket; Silicone
3.5 oz. Tube
(ThreeBond 1207B)
This service procedure requires one tube of ThreeBond 1207B Silicone Gasket per vehicle.
FLAT RATE MANUAL UPDATE INFORMATION
Use the following new labor operation:
Labor time includes 0.1 administrative time allowance.