isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Customer Interest for Transmission Cooler: > < Throttle Valve Cable/Linkage, A/T|Adjustments
Page 1
background image

Transmission Cooler: All Technical Service Bulletins
A/T - High Pitched Humming Noise

BULLETIN NUMBER 
SB91-05-001

ISSUE DATE 
May 2, 1991

GROUP 
TRANSMISSION

TROOPER II (KT) AUTOMATIC TRANSMISSION NOISE

AFFECTED VEHICLES

Trooper II (KT) models with 4ZE1 engine equipped with automatic transmission.

SERVICE INFORMATION

Some affected vehicles may experience a highpitched humming noise coming from the transmission while driving under load. The noise may be caused
by a miscalibrated oil cooler bypass valve, which is located in the lower valve body.

Installing a new, improved oil cooler bypass valve and spring (see "Parts Information" section of this Service Bulletin) will eliminate the noise.

SERVICE PROCEDURE

1.

Remove the valve body as described in the appropriate Workshop Manual.

2.

Remove and discard the oil cooler bypass valve and spring (Figure 1). Install a new, improved oil cooler bypass valve and spring. See "Parts
Information" section of this Service Bulletin.

3.

Reinstall the valve body as described in the appropriate Workshop Manual.

PARTS INFORMATION

FLAT RATE MANUAL INFORMATION

Use existing Flat Rate Manual labor operation number 051101.

Customer Interest for Transmission Cooler: > < Throttle Valve Cable/Linkage, A/T|Adjustments