Trooper LS 2WD V6-3.5L (2001)
1. Disconnect the battery ground cable.
2. Remove rear door sill plate and the luggage side lower cover.
3. Remove rear door seal finisher (1).
-
Pull the rear door seal finisher (1) out from the body panel.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Insert the rear door seal finisher (2) into the A corner and install the finisher in the arrow-marked directions.
2. Be careful not to allow the sill plate and the cover to distort or twist the finisher.