Trooper LS 2WD V6-3.5L (2001)
2. When installing the steering column cover, be sure to route each wire harness as illustrated so that the harnesses do not catch on any moving parts.
3. Align the setting marks made when removing then install steering wheel.
Caution: Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the
steering wheel. The steering shaft is designed as an energy absorbing unit.
4. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
5. Support the inflator module and carefully connect the module connector.
Caution:
-
Never use the air bag assembly from another vehicle. Use only the air bag assembly for "UX".
-
The driver's air bag assembly (inflator module) for 2000 model has different characteristic to the parts for 2000 model.
When replace the driver's air bag assembly, confirm the parts number and use only the parts for 2000 model.
(The driver's air bag assembly for 2000 model has "yellow" bar codes label. 2000 model has "white" bar codes label.)
Note: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
6. Secure the module with one bolt to relieve weight on the wire connector.
7. Tighten bolts to specified sequence as illustrated.
Torque: 8 Nm (69 inch lbs.)
8. Install steering lower cover then Install the engine hood opening lever.
