Trooper LS 2WD V6-3.5L (2001)
![background image](/isuzu/trooper_ls_2wd/v6-3.5l/Page-228001.png)
Camshaft Position Sensor: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Remove the common chamber assembly. Refer to Common Chamber in Engine Mechanical.
4. Disconnect the electrical connector to the CMP sensor.
5. Remove the CMP retaining bolt from the side of left cylinder head.
6. Remove the CMP sensor from the cylinder head.
INSTALLATION PROCEDURE
1. Install the CMP sensor in the cylinder head.
2. Install the CMP sensor retaining bolt.
Tighten
Tighten the retaining screw to 9 N.m (78 lb in.).
3. Connect the electrical connector to the CMP sensor.