Trooper LS 2WD V6-3.5L (2001)
2. Install front bushing by using installer J-36833.
3. Install lower ball joint bolt.
4. Install torsion bar arm bolt.
5. Install lower control arm.
6. Install rear bolt.
7. Install front bolt.
8. Install lower ball joint and tighten it to the specified torque.
Torque: 103 Nm (76 ft. lbs.)
9. Install shock absorber and tighten it to the specified torque.
Torque: 82 Nm (61 ft. lbs.)
10. Install stabilizer link and tighten it to the specified torque.
Torque: 50 Nm (37 ft. lbs.)
11. Install torsion bar arm bracket and tighten it to the specified torque.
Torque: 116 Nm (85 ft. lbs.)
12. Install Torsion bar.
13. Install rear nut and washer and tighten lower link nut finger- tight.
Note: Torque lower control arm nut after adjusting buffer clearance.
Buffer clearance: 20 mm (0.79 inch)
Torque: 196 Nm (145 ft. lbs.)
14. Install front nut and washer then tighten lower link nut finger-tight.
Note: Torque lower control arm nut after adjusting buffer clearance.
Buffer clearance: 20 mm (0.79 inch)
Torque: 157 Nm (116 ft. lbs.)
Note: Adjust the trim height.
