Trooper LTD V6-3165cc 3.2L SOHC MFI (6VD1) (1997)
Refrigerant Pressure Sensor / Switch: Service and Repair
Preparation:
Disconnect the battery ground cable. Discharge and recover refrigerant (Refer to "REFRIGERANT RECOVERY")
1. Radiator grille
2. Pressure switch connector
3. Pressure switch
-
When removing the switch connected part, the connecting part should immediately be plugged or capped to prevent foreign matter from being
mixed into the line.
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
1. O-ring cannot be reused. Always replace with a new one.
2. Be sure to apply new compressor oil to the O-ring when connecting pressure switch.
3. Tighten the pressure switch to the specified torque.
Torque: N.m (lb.in) = 13 (113)