Trooper LTD 4WD V6-3.5L (2002)
4) Measure dimension (4).
Dimension (4) (Standard): -0.1 - 0.1 mm (-0.0039 - 0.0039 inch)
5) If dimension (4) is out of the standard range, adjust push rod using the Push Rod Support J-39241.
6) Mount plate and seal assembly in vacuum booster front shell. Then install the retainer.
7) Install vacuum booster fixing nut and tighten the specified torque.
Torque: 21 Nm (16 ft. lbs.)
8) Install yoke clevis.
9) Connect vacuum hose and make sure that the arrow on the hose points in the direction of the engine.
10) Install master cylinder.
