Checking and Adjusting Oil For Replacement Compressor
Refrigerant Oil: Service and Repair
Checking and Adjusting Oil For Replacement Compressor
Compressor Replacement
Checking and Adjusting for Compressor Replacement
The oil used to lubricate the compressor is circulating with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
150 cu.cm (5.0 fl. oz.) or oil is charged in compressor (service parts). So it is necessary to drain the proper amount of oil from the new compressor.
1. Perform oil return operation.
2. Discharge and recover the refrigerant and remove the compressor.
3. Drain the compressor oil and measure the extracted oil.
4. Check the compressor oil for contamination.
5. Adjust the oil level as required.
6. Evacuate, charge and perform the oil return operation.
7. Check the system operation.
Oil Quantity For Used Compressor
Checking and Adjusting Oil Quantity for Used Compressor
The oil used to lubricate the compressor is circulating with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
1. Perform oil return operation. Refer to Oil Return Operation.
2. Discharge and recover refrigerant and remove the compressor.
3. Drain the compressor oil and measure the extracted oil with a measuring cylinder.
4. If the amount of oil drained is much less than 90 cu.cm (3.0 fl. oz.), some refrigerant may have leaked out. Conduct a leak tests on the connections
of each system, and if necessary, repair or replace faulty parts.
5. Check the compressor oil contamination. (Refer to Contamination of Compressor Oil.)
6. Adjust the oil level following the next procedure below.
7. Install the compressor, then evacuate, charge and perform the oil return operation.
8. Check system operation.
When it is impossible to perform oil return operation, the compressor oil should be checked in the following order:
1. Discharge and recover refrigerant and remove the compressor.
2. Drain the compressor oil and measure the extracted oil with a measuring cylinder.
3. Check the oil for contamination.
4. If more than 90 cu.cm (3.0 fl. oz.) of oil is extracted from the compressor, supply the same amount of oil to the compressor to be installed.
5. If the amount of oil extracted is less than 90 cu.cm (3.0 fl. oz.), recheck the compressor oil in the following order:
6. Supply 90 cu.cm (3.0 fl. oz.) of oil to the compressor and install it onto the vehicle.
7. Evacuate and recharge with the proper amount of refrigerant.
8. Perform the oil return operation.
9. Remove the compressor and recheck the amount of oil.
