Trooper LTD 4WD V6-3.5L (2002)
Vehicle Speed Sensor: Description and Operation
Vehicle Speed Sensor (VSS)
The PCM determines the speed of the vehicle by converting a plusing voltage signal from the vehicle speed sensor (VSS) into miles per hour. The PCM
uses this signal to operate the cruise control, speedometer, and the TCC and shift solenoids in the transmission. For more information on the TCC and
shift solenoids, refer to 4L30-E Automatic Transmission section.
IMPORTANT:The vehicle should not be driven with the transmission range switch disconnected; idle quality will be affected.
Do not use a test light to diagnose the powertrain electrical systems unless specifically instructed by the diagnostic procedures. Use Connector Test
Adapter Kit J 35616 whenever diagnostic procedures call for probing connectors.
Circuit Operation
With the starter switch in ON or START the VSS receives power. For every rotation, the VSS outputs four pulses to the engine (M/T) or powertrain
(A/T) control module (ECM or PCM), and the speedometer to gauge speed.
