Trooper LTD 4WD V6-3.5L (2002)
Caution: Be careful not to damage the ball joint boot
3. Remove nut and cotter pin, then use remover J-36831 to remove outer track rod assembly from the knuckle arm.
Caution: Be careful not to damage the ball joint boot
4. Remove outer lock nut.
5. Apply setting marks (1) to ensure reassembly of the parts in their original position, then remove outer rod end assembly.
6. Remove inner lock nut.
Note: For either outer rod, the screw on the right side of the vehicle is threaded counterclockwise.
7. Apply setting marks (1) to ensure reassembly of the parts in their original position, then remove inner rod end.
Inspection and Repair
Make necessary correction or parts replacement if wear, damage, corrosion, bending, deteriorations or any other abnormal condition are found through
inspection.
Check the following parts:
^
Rod end assembly
^
Ball joint (Boot, screws and tapered surfaces)
Installation
1. Install inner rod end and align the setting marks applied during disassembly.
2. Tighten the inner lock nut to specified torque.
Torque: 118 Nm (87 ft. lbs.)
Note: For either outer rod, the screw on the right side of the vehicle is threaded counterclockwise.
3. Install outer rod end assembly and align the setting marks applied during disassembly.
