Trooper S V6-3.5L (1998)
8. Apply plastigage to the crankshaft journal unit as shown in the illustration.
NOTE: Do not set the plastigage on the oil hole.
9. Install main bearing caps, oil gallery and crank case bolts in the order shown, and tighten each bolt to the specified torque.
NOTE: Do not apply engine oil to the crank case side bolts.
Main bearing cap bolts:
Torque: 39 Nm (29 ft. lbs.)
Oil gallery fixing bolts.
Torque:
1st step: 29 Nm (21 ft. lbs.)
2nd step: 55° - 65°
Crank case side bolts:
Torque: 39 Nm (29 ft. lbs.)
NOTE: Do not allow the crankshaft to rotate.