Trooper S V6-3.5L (1998)
^
Remove scarf cut seal ring located in first groove of turbine shaft (Figure 1).
NOTE
The first groove is the groove closest to the torque converter.
INSTALLATION
Solid Seal Ring
^
Lubricate first groove of turbine shaft and solid seal ring (from Turbine Shaft Seat Kit) with petroleum jelly.
^
Slip solid seal ring over turbine shaft and position it onto first groove. Use light finger pressure.
IMPORTANT!
The solid seal ring is made of a silicone-based material. This material will stretch during installation, causing an increase in seal ring diameter. To
ensure proper seal ring functioning the seal ring must be resized. Use the sizing tool contained in the Turbine Shaft Seal Kit (Part No.
8-96041-327-0) and the following two steps to resize the solid seal ring
^
Place Sizing tool over turbine shaft and push downward until tool contacts overrun clutch (Figure 2).
^
Wait five minutes, then remove and discard sizing tool.
REASSEMBLY
Transmission Assembly
^
Reassemble in accordance with Section 7A of appropriate Workshop Manual.
PARTS INFORMATION
Part Number
Description
Quantity Required
8-9641-327-0
Turbine Shaft Seal Kit
1
Solid Seal Ring
Sizing Tool
Installation Instructions
FLAT RATE MANUAL UPDATE INFORMATION