Trooper S V6-3.5L (1998)
6. Clutch pedal engagement height inspection:
1. Operate the parking brake lever and block the wheels.
2. Start the engine, fully step on the clutch pedal, and move the shift lever to 1st position.
3. With the engine idling, release the clutch pedal slowly and measure its stroke just prior to its clutching position.
Clutch Pedal Engagement Height (14)
MIN. 30 mm (1.18 inch)
7. If the measured value exceeds the specified limit, check the following points. Repair if necessary:
-
Hydraulic circuit for fluid leakage or air in circuit.
-
Clutch disc warped.
-
Diaphragm spring weakened or tip of fingers worn.
-
Driven plate sticking on splines
-
Release bearing worn or damaged.
-
Master cylinder and slave cylinder worn.
TORQUE SPECIFICATIONS
-
Master cylinder to dash panel
Torque: 16 Nm (12 ft. lbs.)
-
Clutch pedal to dash panel
Torque: 21 Nm (15 ft. lbs.)
-
Master cylinder push rod to yoke
Torque: 17 Nm (12 ft. lbs.)
-
Clutch pipe to master cylinder
Torque: 20 Nm (14 ft. lbs.)
-
Clutch pipe to flex, hose
Torque: 20 Nm (14 ft. lbs.)
-
Slave cylinder to case
Torque: 43 Nm (32 ft. lbs.)
-
Slave cylinder bleeder screw
Torque: 8 Nm(69 inch lbs.)
-
Flexible hose to slave cylinder