Trooper S 2WD V6-3.5L (2001)
5. Install return spring; upper and the parking brake lever (3) side (secondary side) return spring must be installed on the outer side (2) of the primary
side return spring.
6. Install holding spring.
7. Install clip (suspension side) and tighten the bolt to the specified torque.
Torque: 7.8 Nm (68 inch lbs.)
8. Install clip (frame side) and tighten the bolt to the specified torque.
Torque: 15 Nm (11 inch lbs.)
9. Install back plate.
10. Install bolt and tighten the bolt to the specified torque.
Torque: 6 Nm (52 inch lbs.)
11. Install clip (floor side) and tighten the bolt to the specified torque.
Torque: 15 Nm (11 inch lbs.)
12. Install rotor.
13. Install caliper assembly.
14. Install rear wheels.
15. Install adjusting nut and apply grease (BESCO L-2 or equivalent) to front cable contact point.
16. Tighten the adjusting nut to the specified torque and to adjust the parking brake.
Torque: 6 Nm (52 inch lbs.)
Inspection and Repair
Parking Brake Lining Inspection
Check the shoe assemblies for wear by removing the brake drum rotor.
Replace the shoe assemblies if the lining thickness is less than 1.0 mm (0.039 inch).
Minimum limit: 1.0 mm (0.039 inch)
Parking Brake Rotor (Drum) Inspection
For the inspection procedure of the rotor (drum), refer to Disc Brakes.
