Trooper S 2WD V6-3.5L (2001)
10. Remove common chamber four bolts and four nuts then remove the common chamber.
Installation
1. Install common chamber and tighten bolts and nuts to the specified torque.
Torque: Bolt: 25 Nm (18 ft. lbs.)
Nut: 25 Nm (18 ft. lbs.)
2. Install fuel hose bracket and tighten bolts to specified torque.
Torque: 10 Nm (89 inch lbs.)
3. Install exhaust gas recirculation valve assembly and tighten bolt and nut to the specified torque.
Torque: 25 Nm (18 ft. lbs.)
4. Install throttle body and tighten bolts to the specified torque.
Torque: 25 Nm (18 ft. lbs.)
5. Install ventilating hose to throttle valve and intake duct.
6. Connect vacuum hoses on canister VSV and positive crankcase ventilation hose. Tighten bolts for fuel rail assembly with pressure control valve
bracket.
Torque: 25 Nm (18 ft. lbs.)
7. Connect each connector without fail.
8. Connect vacuum booster hose.
