Trooper S 4WD V6-3.5L (2002)
4. Disconnect the drive hose at the frame complete side.
5. Remove the hose fixing tapes and clips.
6. Apply the soap and water to the body panel grommet.
7. Pull the drain hose to the inside of the vehicle.
Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Apply the soap and water to the body panel grommet.
2. Insert the drain hose from inside of vehicle, restore routing, and fix with new soft tape and clip.
If the grommet is removed during removal of drain hose, insert the grommet into drain hose from outside of the vehicle, and install on the body
panel, avoiding any twisting.
3. After installing the drain hose, install the trim while taking care not to crush the drain hose.
Also, care should be taken not to allow the drain hose connected to the pipe to be caught in.
4. Test the drain condition.
5. The protrusion of the drain hose from the body panel must be within 50 mm (2.0 in). If it exceeds 50 mm (2.0 in) after correct routing, cut the
leading edge so that the protrusion is within 50 mm (2.0 in).
