Trooper S 4WD V6-3.5L (2002)
3) Install piston seal and apply special rubber grease to the piston seal and cylinder wall, then insert the piston seal into the cylinder. The special
rubber grease is included in the repair kit.
4) Install piston.
5) Install piston dust boot; when inserting the piston into the cylinder, use finger pressure only and do not use a mallet or other impact tool, since
damage to the cylinder wall or piston seal can result.
6) Install dust boot ring and apply special grease (approximately 1 g) to the piston and attach the dust boot to the piston and caliper. Insert the dust
boot ring into the dust boot.
7) Install guide bolt and lock bolt dust boot.
8) Install lock bolt and guide bolt and tighten the bolt to the specified torque.
Torque: 74 Nm (54 ft. lbs.)
