Trooper S 4WD V6-3.5L (2002)
7. Remove eight fixing bolts, then the cylinder head cover.
Installation
1. Install cylinder head cover.
^
Clean the sealing surface of cylinder head and cylinder head cover to remove oil and sealing materials completely.
^
Apply sealant (TB-1 207B or equivalent) of bead diameter 2-3 mm at eight place of arched area of camshaft bracket on front and rear sides.
^
The cylinder head cover must be installed within 5 minutes after sealant application to prevent premature hardening of sealant.
^
Tighten bolts to the specified torque.
Torque: 9 Nm (80 inch lbs.)
2. Install fuel injection harness bracket and tighten bolt to the specified torque.
Torque: 9 Nm (80 inch lbs.)
