Trooper S 4WD V6-3.5L (2002)
Fuel Metering System: Description and Operation
Fuel Metering System Description
Fuel Metering / System Description
The PCM provides extra fuel when it detects a rapid increase in the throttle position and the air flow.
When battery voltage is low, the PCM will compensate for the weak spark by increasing the following:
-
The amount of fuel delivered.
-
The idle RPM.
-
Ignition dwell time.
Clear a flooded engine by pushing the accelerator pedal down all the way. The PCM then de-energizes the fuel injectors. The PCM holds the fuel
injectors de-energized as long as the throttle remains above 80% and the engine speed is below 800 RPM. If the throttle position becomes less than 80%,
the PCM again begins to pulse the injectors "ON" and "OFF," allowing fuel into the cylinders.
The PCM reduces the amount of fuel injected when it detects a decrease in the throttle position and the air flow. When deceleration is very fast, the PCM
may cut off fuel completely for short periods.
The PCM monitors engine speed. It turns off the fuel injectors when the engine speed increase above 6400 RPM. The fuel injectors are turned back on
when engine speed decreases below 6150 RPM.
No fuel is delivered by the fuel injectors when the ignition is "OFF." This prevents engine run-on. In addition, the PCM suspends fuel delivery if no
reference pulses are detected (engine not running) to prevent engine flooding.
The sequential multiport fuel injection (SFI) fuel injector is a solenoid-operated device controlled by the PCM. The PCM energizes the solenoid, which
opens a valve to allow fuel delivery.
