Trooper S 4WD V6-3.5L (2002)
4. Install oil filter with a new gasket and the three 13 mm screws. Tighten the screws to the specified torque.
Torque: 20 Nm (15 ft. lbs.)
5. Install magnet, main case oil pan with new gasket, sixteen 10 mm screws. Tighten the screws to the specified torque.
Torque: 11 Nm (96 inch lbs.)
6. Install third crossmember and rear mount nuts. Tighten the nuts and bolts to the specified torque.
Third crossmember bolt: 76 Nm (56 ft. lbs.)
Rear mount nut: 50 Nm (37 ft. lbs.)
7. Install the transfer protector. Tighten the bolts to the specified torque.
Torque: 37 Nm (27 ft. lbs.)
8. Fill transmission through the overfill screw hole of oil pan, using ATF DEXRON III.
9. Connect the battery ground cable.
