Trooper S 4WD V6-3.5L (2002)
Then from where it stops, turn it back about 3 rotations to set the alignment marks (7) together before installing the steering wheel.
2. Tighten the steering shaft nut to the specified torque.
Torque: 34 N.m (25 lb ft)
3. When connecting the double lock type of inflator module connector, insert the connector completely and lock at outside.
Imperfect locking may cause malfunction of SRS system circuit.
4. When installing the steering cowl (11), be sure to pass the harnesses through the route as shown in the figure so that the starter switch harness (8),
the combination switch harness (9) and inflator module harness (10) will not get caught.
