Trooper S 4WD V6-3.5L (2002)
Wiper Switch: Service and Repair
Windshield Wiper and Washer Switch
Windshield Wiper And Washer Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the instrument panel driver lower cover (5). Refer to the Instrument Panel Assembly in Body Structure.
3. Remove seven screws to remove the steering cowl (4).
4. Disconnect the SDM (air bag controller) connector located at lower of the instrument panel driver lower cover.
5. Remove four fixing screws and disconnect the driver inflator module connector to remove the driver inflator module (3).
CAUTION: When carrying a live inflator module, make sure the bag opening is pointed away from you. In case of an accidental deployment, the
bag will then deploy with minimum chance of injury. Never carry the inflator module by the wires or connector on the underside of the module.
When placing a live inflator module on a bench or other surface, always face the bag and trim cover up, away from the surface. This is necessary
so that a free space is provided to allow the air bag to expand in the unlikely event of accidental deployment.
6. Remove the steering wheel (2). Refer to the Steering Wheel in Steering action.
7. Disconnect the SRS coil assembly connector, remove four fixing screws to remove the SRS coil assembly (1).
8. Disconnect the lighting switch connector, remove four fixing screws to remove the lighting switch (6).
Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Check to see if the vehicle is in the straight driving condition and turn the rotary section of the SRS coil assembly provided to the upper surface of
the lighting switch (combination switch) counterclockwise fully until it stops.
