VehiCROSS 4WD V6-3.5L (1999)
Lower Side Moulding / Trim: Service and Repair
Tailgate Protector
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate protector.
-
Remove the four bolts and pull out the tailgate handle.
-
Remove the four inside hex screws, the five fixing cap nuts and disengage the four clips.
-
Pull out the portion of the double-sided adhesive tape of protector from body panel carefully.
Installation
To install, follow the removal steps in the reverse order, noting following points:
1. Use a new double-sided adhesive tape whenever installing the tailgate protector. Using a white gasoline, clean the places in advance where a
double-sided adhesive tape is affixed.
2. To tear the remaining old double-sided adhesive tape off, use 3M * or equivalent.