VehiCROSS 4WD V6-3.5L (1999)
3. Connect the other lead to a known good ground.
4. Beginning near the fuse box, wiggle the harness. Continue this at convenient points about six inches apart while watching the test light or
ohmmeter.
5. If the self-powered test light blinks or the ohmmeter needle moves, there is a short to ground in the wiring near that point.
Testing For Voltage Drop
This test checks for voltage drop along a wire, or through a connection or switch.
1. Connect the positive lead of a voltmeter to the end of the wire (or to the side of the connector or switch) closest to the battery.
2. Connect the negative lead to the other end of the wire (or the other side of the connector or switch).
3. Operate the circuit.
4. The voltmeter will show the difference in voltage between the two points. A difference, or drop of more than 0.5 volts may indicate a problem.
Check the circuit for loose or dirty connections.
Testing For Voltage
This test measures voltage in a circuit. When testing for voltage at a connector, you may not have to separate the two halves of the connector. Instead,
probe the connector from the back. Always check both sides of the connector because din and corrosion between its contact surfaces can cause electrical
