isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Illumination Controller <--> [Dimmer Switch] > < Technician Safety Information|Page 4537
Page 1
background image

Air Bag(s) Arming and Disarming: Service and Repair

WARNING:  WHEN PERFORMING SERVICE ON OR AROUND SRS COMPONENTS OR SRS WIRING, FOLLOW THE PROCEDURES
LISTED BELOW TO TEMPORARILY DISABLE THE SRS. FAILURE TO FOLLOW PROCEDURES COULD RESULT IN POSSIBLE
AIR BAG DEPLOYMENT, PERSONAL INJURY OR OTHERWISE UNNEEDED SRS REPAIRS.

The SDM in Driver-Passenger SRS can maintain sufficient voltage to cause a deployment for up to 15 seconds after the ignition switch is turned "OFF",
the battery is disconnected, or the fuse powering the SDM is removed. Many of the service procedures require removal of the "SRS-2" fuse, and
disconnection of the air bag assembly from the deployment loop to avoid an accidental deployment. If the air bag assembly is disconnected from the
deployment loop as noted in the "Disabling the SRS" procedure that follows, service can begin immediately without waiting for the 15 seconds time
period to expire.

Disabling The SRS - Removal

Turn the ignition switch to "lock" and remove key.

1. Remove SRS fuse "SRS-1" and "SRS-2", from left dash side lower fuse block or disconnect battery.
2. Disconnect yellow 2-pin connector at the base of steering column.
3. Remove glove box assembly.
4. Disconnect yellow 2-pin connector behind the glove box assembly.

CAUTION:  With the "SRS-2" fuse removed and ignition switch "ON", "AIR BAG" warning lamp will be "ON". This is normal operation and
does not indicate an SRS malfunction.

Enabling The SRS - Installation

CAUTION:  Never use the air bag assembly from another vehicle. Use only the air bag assembly for Vehi CROSS (VX) models.

Turn ignition switch to "LOCK" and remove key.

1

Connect yellow 2-pin connector passenger air bag assembly.

2. Install glove box assembly.
3. Connect yellow 2-pin connector at the base of steering column.
4. Install "AIR BAG" fuse "SRS-1" and "SRS-2" to left dash side lower fuse block or connect battery. 

Turn ignition switch to "ON" and verify that the "AIR BAG" warning lamp flashes seven times and then turns "OFF" If it does not operate as described,
perform the "Supplemental Restraint System (SRS) Diagnostic System Check".

Illumination Controller <--> [Dimmer Switch] > < Technician Safety Information|Page 4537