VehiCROSS 4WD V6-3.5L (1999)
1. Install combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring
harness connector. Then turn the SRS coil counterclockwise to full, return about 3 turns and align the neutral mark.
CAUTION: When turning the SRS coil counterclockwise to full, stop turning if resistance is felt. Forced further turning may damage to the cable
in the SRS coil.
2. When installing the steering column cover, be sure to route each wire harness as illustrated so that the harnesses do not catch on any moving parts.
3. Align the setting marks made when removing then install steering wheel.
CAUTION: Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the
steering wheel. The steering shaft is designed as an energy absorbing unit.
4. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
5. Support the inflator module and carefully connect the module connector and horn lead.
CAUTION: Never use the air bag assembly from another vehicle. Use only the air bag assembly for "VX".