VehiCROSS 4WD V6-3.5L (1999)
Axle Nut: Specifications
Install hub nut. Turn to the place where there is a chamfer in the tapped hole to the outer side, then attach the nut by using front hub nut wrench
J-36827.
Preload Adjustment
1. Tighten the hub nut to 29 Nm (22 ft. lbs.), then fully loosen the nut.
2. Tighten the hub nut to the value given below, using a spring scale on the wheel pin.
New bearing and New oil seal
Bearing Preload: 20 N - 25 N (4.4 lb. - 5.5 lb.)
Used bearing and New oil seal
Bearing Preload: 12 N - 18 N (2.6 lb. - 4.0 lb.)
If the measured bearing preload is outside the specifications, adjust it by loosening or tightening the bearing nut.
