VehiCROSS 4WD V6-3.5L (1999)
4. Install the steering column cover (3).
CAUTION: When installing the steering column cover, be sure to through each harness as illustrated so that the harnesses starter switch,
combination switch and SRS coil may not catch wiring.
5. Install the driver knee bolster assembly.
6. Install the steering lower cover.
7. Install the steering wheel and align the setting marks (4).
8. Tighten the steering wheel fixing nut (5) to the specified torque.
Torque: 34 Nm (25 lb.ft)
9. Connect horn lead (1).
10. Connect air bag to wiring harness connector (2).
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air bag to prevent lead wire from being pinched.
11. Install Air Bag (6) into steering wheel and tighten bolts (8) to specified sequence as figure.
Torque: 8.8 Nm (78 lb.in)
CAUTION: Never use the air bag assembly from another vehicle. Use only the air bag assembly for Vehi CROSS (VX).
12. Enable the SRS.
