VehiCROSS 4WD V6-3.5L (1999)
steering wheel. The steering shaft is designed as an energy absorbing unit.
9. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
10. Support inflator module and carefully connect the module connector and horn lead, then install inflator module.
CAUTION: Never use the air bag assembly from another vehicle. Use only the air bag assembly for "VX".
NOTICE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
11. Tighten fixing bolts to specified torque.
Torque: 8.8 Nm (78 inch lbs.)
12. Install instrument panel lower cover, then install the engine hood opening lever.
13. Connect the yellow 3-way SRS connector located under the steering column.
14. Connect the battery "-" terminal cable.
SYSTEM INSPECTION
Turn the ignition switch to "ON" while watching warning light. The light should flash 7 times and then go off. If lamp does not operate correctly, refer
to Air Bags (Supplemental Restraint Systems).