VehiCROSS 4WD V6-3.5L (1999)
Starter Motor: Service and Repair
Removal and Installation
Removal
1. Disconnect battery ground cable.
2. Disconnect Heated Heated Oxygen (O2) Sensor connectors (1).
3. Remove exhaust front left pipe (2).
4. Remove heat protector (3).
5. Disconnect starter wiring connector from terminals "B" and "S" (4).
6. Remove starter assembly mounting bolts on inside and outside (5).
7. Remove starter assembly toward the bottom of engine (6).
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Install starter assembly (6).
2. Install mounting bolts and tighten bolts to specified torque (5).
Torque: 40 Nm (30 lb.ft)
