VehiCROSS 4WD V6-3.5L (1999)
Seals and Gaskets: Service and Repair
Oil Seal Replacement
Remove the oil seal, carefully not to damage the housing, and mount new oil seal using oil seal installer J-39210.
Installation
1. Install differential assembly.
2. Install axle shaft assembly then tighten the bearing holder mounting nut to the specified torque. Be sure not to damage the oil seal by the spline of
the shaft.
Torque: 74 Nm (54 ft. lbs.)
3. Install brake line.
4. Connect Antilock Brake System (ABS) speed sensor and harness.
5. Install brake disc.
6. Install brake caliper.
7. Install axle housing assembly.
8. Install coil spring and insulator.
9. Install the trailing link fixing bolt and nut to the axle housing.
10. Install the center link bolt and nut to the axle housing.
11. Install the lateral rod fixing nut to the axle housing.
12. Install the stabilizer linkage mounting nut to the axle housing.
13. Install the shock absorber fixing nut to the axle housing.
14. Install brake tube flare nut.
15. Install ABS connector and bracket.
16. Connect breather hose.
17. Install parking brake cable.
18. Bleed brakes.
