Majestic L6-3.6L (1989)
-
Front brake disc run 0.005 in maximum
-
out (parallelism)
SERVICE TOOLS
-
18G 134 Driver handle
-
JD 550-5/1 Adaptor
-
JD 550-5/2 Adaptor
TORQUE FIGURES
-
Caliper carrier to vertical link 102-128 Nm
-
Caliper to carder 31-40 Nm
-
Disc to hub 11-16 Nm
-
Wheel nut to stud (steel wheel) 65-85 Nm
-
Wheel nut to stud (alloy wheel) 88-102 Nm
SPANNER SIZES
-
13mm
-
17mm
-
22mm
-
15/16AF
OILS/GREASES
-
Hub bearings/cap Shell Retinax A
-
Seal lip cavities Shell Alvania 3
HUB BEARING END FLOAT
-
Slacken off the road wheel nuts 1/4 turn each.
-
Jack up the front of the vehicle and support with axle stands.
-
Remove one wheel nut, mark the wheel relative to the stud, and remove the remaining wheel nuts.
-
Remove the road wheel and tire assembly.
-
Pry off the hub grease cap (1 Fig 1).
-
Remove the hub nut split pin and cover (2,3 Fig 1).
-
Tighten the nut to obtain an end float of 0.0762-0.0254mm (0.003-0.001 in).
-
Align the hub nut cover and secure with a new split pin.
-
Refit the grease cap.
-
Refit the road wheel.
-
Lower the vehicle from the stand.
DATA
-
Front hub to stub axle end float 0.0762-0.0254mm (0.003-0.001 in)
-
Front brake disc run out 0.004 in maximum
-
Front brake disc run 0.005 in maximum
-
out (parallelism)
TORQUE FIGURES
-
Wheel nut to stud (steel wheel) 65-85 Nm
-
Wheel nut to stud (alloy wheel) 88-102 Nm
SPANNER SIZES
-
22mm
-
15/16AF
OILS/GREASES
-
Hub bearings/cap Shell Retinax A
HUB BEARING
-
Slacken off the front road wheel nuts 1/4 turn each.
-
Jack up the front of the vehicle and support with axle stands.
-
Remove one wheel nut, mark the wheel relative to the stud, and remove the remaining wheel nuts.
-
Remove the road wheel/tire assembly.